Initial impressions:This was a great price for a "bulk" filament buy.Rolls are not perfectly rolled but I have not had any binds or issues even when using an AMS unit. My standard for this is lower for single discrete color filaments. It prints less than glossy but not quite "matte" in a faster printer like Bambu Labs X1s, so you might get different results with a slower printer perhaps edging closer to the shine of a PLA basic.It suggests that it is dimensionally accurate and while I did not perform specific tests for that, I can tell you it prints quite rigid and stiff. There are models I print that require two parts to click together typically needing a little material flex to pop them together. This does not budge at all. So if you are looking for rigid which dimensionally accurate parts may demand, this will do it. If you are looking for something that will flex a little, fuggadaboutit. That is a pro or con depending on your use case.I have not done any stress testing but my impression is that it is quite strong and layers adhere well based on the models I have printed so far. Stringing was not evident at all. Bridging was average, not impressive. Those last two observations will depend mostly on your slicer settings and filament profile so your mileage may vary. And to be fully tranparent mine are not dialed in at all and I have only printed a little more than 1 roll of this.Overall, highly recommended for the price. This a working bargain filament, it's not going to give the prettiest color or shine but the prints are clean and strong. It jmhas shown no sign of being brittle. At the price it is hard to beat. Paintability was not tested but it looks like it would do as well as any PLA for printing.I will edit the review if down the road anything radically changes. At this point it is a great basic filament value probably great for printing functional parts/prototyping and adequate for more decorative pieces assuming you are good with the potebtialky flat color/finish or intend to paint.